| || |
It's been a long time since I messed with Nylon filament, but I needed an example of different materials for something I'm trying to get going at work. I had really good success with Taulman Bridge at 250C and the bed heated to 45C. I coated the glass plate with Elmers glue and didn't have any trouble keeping the part adhered to the bed. When it cooled off it popped right off. I sliced the part using a spiral mode, so there were no retractions which made for a nice clean part with no Z seams.
Printing with Nylon
The goofy little cylinder I have on top is just a place holder until I can figure out the detail. I borrowed a couple of cars from the SketchUp warehouse because they look kinda cool.