Abstract2actual
  • Home
  • Blog
  • Gallery
  • Buy stuff
  • Contact
  • About

Printing with Nylon

2/4/2018

0 Comments

 
It's been a long time since I messed with Nylon filament, but I needed an example of different materials for something I'm trying to get going at work. I had really good success with Taulman Bridge at 250C and the bed heated to 45C.  I coated the glass plate with Elmers glue and didn't have any trouble keeping the part adhered to the bed.  When it cooled off it popped right off.  I sliced the part using a spiral mode, so there were no retractions which made for a nice clean part with no Z seams.  
0 Comments



Leave a Reply.

    View my profile on LinkedIn

    TJ Emsley

    Lifetime tinkerer.

    Archives

    October 2022
    January 2021
    November 2020
    October 2020
    September 2020
    February 2018
    January 2018
    January 2017
    October 2016
    August 2016
    July 2016
    June 2016
    May 2015
    April 2015
    March 2015
    February 2015
    December 2014
    October 2014
    August 2014
    July 2014
    May 2014
    April 2014
    March 2014
    November 2013
    October 2013

    Categories

    All
    3d Design
    3d Printing
    Open Source

    RSS Feed




Proudly powered by Weebly